Login or Register                                                                                            

HOME | message board | articles | videos | photos | polls |

11/27/2018 4:24:51 PM Reply      or ReplyNewSubject Section 8: Handguns Subject: Norinco 1911                          Msg# 1029747 From: Stu Wayne     Joined 4/4/2000 To: Mark Freburg (Read) Forum Manager     Joined 4/3/2000

Yeah, that was my ultimate concern.  I knew I had cleared that but didn't know how much additional clearance - if any - was needed for the possible factors I mentioned. Stu

For reference, the above message is a reply to a message where: I did the initial install and set the stop but I was nervous about just how close it could be set without environmental changes or dirt affecting it...  How about how close it could be without the trigger not moving forward enough for the sear to clear the hammer hooks!  That'll ruin a trigger job pretty quick.

message board home

---

---

 
Top of Page  |  Previous   Privacy Policy  |   Email Us | About | Terms of Use




Powered by ForumsAmerica.com Version: 05012012.1
ForumsAmerica.com is a Registered Trademark