8/26/2016 10:51:03 PM
Reply
or ReplyNewSubject
Section 8: Handguns Subject: revolver Msg# 960129
|
||||||
the inner ring and outer ring are off set. the top pin hits the outside ring and then the lower pin hit the lower primer. while the top pin goes into a hole between rims of outer when up primer is hit the lower goes into a hole between rims. yes I still have it because it is cartridge. will go when I do cutting the teeth in the rachet was a b.... I had to set the hand as close to the hammer pin as possible to cut down on hand throw | ||||||
|
||||||
For reference, the above message is a reply to a message where: Elmer, I got to wondering about this 20-shot revolver when the picture came up on the home page today. Did you put two fixed firing pins on the hammer or do you have a mechanism to move the pin from alignment with the inner ring of chambers to the outer one, something like the LeMat revolver? It's a very cool gun, Elmer - do you still have it? Stu Image below from ElmerJohnston - Image Title: photos Image Info: front |