Reading all
63 messages in thread
message board home
message board home
Next
11/24/2018 2:44:52 PM
 
Reply
or ReplyNewSubject
Section 8: Handguns Subject: Norinco 1911 Msg# 1029623
|
||||||
|
Was that Ken something, the guy who tried to make his drill press rigid enough to use as a milling machine? While he didn't turn his drill press into a Bridgeport mill, he did do some light milling fairly successfully as I recall and might have scrubbed the logo off that way.
Stu |
||||||
|
|
||||||
|
For reference, the above message is a reply to a message where: We had a guy on GEnie who effectively planed the flats of his Nork and removed that stamping, as deep as it was. Fellow out of Florida. Do you remember who that was? |
