Reading all
8 messages in thread
message board home
message board home
Next
10/25/2020 10:29:11 PM
 
Reply
or ReplyNewSubject
Section 6: Rifles Subject: Sharps and Hankin Msg# 1102967
|
||||||
| the barrel is on square groves cut into the frame. is a link and the lever. when closed the lever over rides the link and locks it closed. the extractor traps the case in the standing frame. and the barrel moves forward of it. my problem is the old one was made in rimfire. had to put the pin down under the hammer in the middle of the frame. also did away with the automatic safety. did put in a healty half cock notch. is a screw to set trigger engagement. | ||||||
|
|
||||||
|
For reference, the above message is a reply to a message where: Does the whole thing slide as it looks like it does? |
